The zippered side panels let one cover suit a range of caravan drawbars. Open or close the zips to match how far your stoneguard sits from the hitch, and the cover draws in neatly to your setup. Everything you need is in the mounting kit.

What is in your mounting kit

How to fit the cover

1. 1

   Unzip the side panels

   Open the zips on both side panels so the cover can spread over your setup.

   

2. 2

   Position the cover and secure the nose

   Sit the nose of the cover over the tow hitch and drape the middle panel over the stoneguard. Do up the underside strap to hold it in place.

   

3. 3

   Fit the middle panel hooks

   Screw two hooks to the rear face of the stoneguard, 120 cm apart and centred on the drawbar. Feed a cam buckle strap through each corner eyelet of the middle panel, wrap it around the nearest hook and pull it taut. Firm, not overtightened.

   

   

4. 4

   Close the side zips

   Zip both side panels closed, fully or up to the top edge of the stoneguard.

   

5. 5

   Secure the side panelsOPTIONAL

   Want a little extra hold? Fit hooks through the corner eyelets of the side panels.

   

6. 6

   Fasten the underside straps

   Do up the remaining underside straps. The rearmost strap can go (A) around the rear of the stoneguard or (B) under the drawbar, whichever suits your setup.

7. 7

   Final check

   The cover should sit firm and taut. Do not overtighten, as this strains the eyelets and seams. That is it, your drawbar is covered while the van is parked or stored. Remove the cover before towing.