H2Flow Flush Mount Water Gauge with Flow Sensor

• Water Gauge.
• Flow Sensor with the thread specifications of 1/2in BSP Male.
• 12v System.
• 2-Pin inlet lead cable to power system. Recommended to get the 12v power from the water pump circuit.
• 3-Pin outlet 1.4m lead for flow sensor connection.
• Customise it to either litre or gallon.
• Large backlit LDC Screen.
• One unit is capable of calculating the total volume of multiple tanks up to 99,999 litres.
• Real-time display of water usage, not just Full/half full/empty.

• Cut a made-to-measure hole and push the gauge into place, be sure to secure the screws.  
• Install the flow sensor 20cm after the water pump, and ensure it's fitted with the water flow in the direction of the arrow.
• Cut a section on your John guest water pipe and add John Guest fittings to each side. If you have a softer 12mm food-grade hose choose to add our brass fittings with pipe clamps. Use plumbing tape to avoid leaks.
• Screw in the flow sensor and attach the 12V 3-pin cord to the gauge outlet, to start getting readings.

Please Note: Do not cut the flow sensor leads this will void your warranty. Use 1.4m or 3m extension leads instead.

Documents

• Instructions.